CEECO SSP-511-D2 Wartungshandbuch PDF herunterladen (Seite 8)

Issue 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

4.0 TESTING/OPERATION

4.1 With the phone connected to a working telephone line, press the “CALL”

button located on the front of the telephone. The LED will illuminate red

at this time.

4.2 If any PBX access code or number was programmed (section 3.6), it will

automatically dial out, before the programmed auto-dial number. There

will be an approximate one (1) second pause between the two numbers.

4.3 If no PBX access code or number was programmed, the auto-dial number

will simply dial out (section 3.7). When the called party answers, the LED

will turn GREEN after a maximum of four seconds, if the ADA feature

was activated during programming. A normal speakerphone conversation

should be allowed.

4.4 If a second auto-dial number was programmed (section 3.8) and the first

auto-dial number receives the selected number of unanswered rings

(section 3.9), the phone will automatically reset and dial the second auto-

dial number. If that second number receives the same number of

unanswered rings, the phone will automatically reset and dial the first

auto-dial number again. This oscillation will occur as long as the phone

continues to receive the selected number of unanswered rings. When the

called party answers, the LED will turn GREEN after a maximum of four

seconds and a normal speakerphone conversation should be allowed.

4.5 When the call is complete, press the “CALL” button again to hang up the

phone. The call will be terminated and the LED will go out. If an

automatic call disconnect was programmed (section 3.9 Digit 2), allow the

conversation to continue past the set time (1-9 minutes). Once the time

limit expires, the phone will automatically disconnect the call. A three-

tone error signal will be heard as the call is disconnected. The time is not

exact.

4.6 If the phone was programmed to allow incoming calls (section 3.9 Digit 1)

place a call into the phone. When the phone rings, press the “CALL”

button. The microphone should activate approximately three seconds after

the call is answered and a normal speakerphone conversation should

follow. If the phone was programmed not to allow incoming calls, the

microphone will not turn on.

4.7 Testing is now complete. If trouble was encountered please refer to

section 10.2 of this manual, otherwise the phone is operational.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

CEECO SSP-511-D2 Wartungshandbuch Seite 8