CEECO SSP-511-D2 Wartungshandbuch PDF herunterladen (Seite 4)

Issue 4.0

CEECO

Communication Equipment & Engineering Company

PROPRIETARY

1.0 INTRODUCTION

The practices in this manual provide installation and maintenance information for

Model WPP-531-D2 or Model SSP-511-D2 Telephone, with optional second-

number auto-dial feature and optional ADA feature, equipped with

SPK1.07UNVL firmware.

The information in this manual is subject to change without notification.

For information not included in this manual, please call or write:

CEECO

Customer Service

519 SW Park Street

Okeechobee, FL 34972

863-357-0798 Voice

863-357-0006 Fax

www.ceeco.net

2.0 GENERAL

2.1 The CEECO hands free telephone is a sturdy, vandal resistant, stainless

steel speakerphone. Instead of a hookswitch and handset, the telephone

has a press to start/press to stop CALL button for the initiation and

termination of phone calls. Manual volume control is also provided inside

the telephone on the PC board.

2.2 The telephone provides an optional second-number auto-dial feature. This

allows a second number to be automatically dialed, when no answer is

received on the first auto-dial number. The phone can be programmed to

select the number of unanswered rings (1-9), after which it will

automatically release the second auto-dial number.

2.3 The telephone also has an optional ADA feature. This feature causes the

LED to illuminate RED during off-hook and dialing conditions and turn

GREEN after answer.

2.4 The microphone is muted during periods of dial tone to deter the use of

hand-held dialers to make fraudulent calls.

2.5 Incoming calls may be allowed or blocked and an automatic call

disconnect may be selected (1-9 minutes) depending on the programming.

2.6 Programming is accomplished by way of a DTMF keypad, which is

attached to the back of the telephone panel or provided separately.

1 2 3 4 5 6 7 8 9 ... 14 15

Keine Kommentare

CEECO SSP-511-D2 Wartungshandbuch Seite 4